Units & Measurement Codexery

Knot (unit)

Unit of speed equal to one nautical mile per hour.

Last updated

The knot (symbol kn, or kt in aviation) is a unit of speed equal to one nautical mile per hour—exactly 1.852 km/h, or roughly 1.151 mph and 0.514 m/s. It is a non-SI unit used in meteorology, maritime navigation, and air navigation. The International Civil Aviation Organization (ICAO) recommends the symbol kt, while the ISO standard is kn. A vessel moving at one knot along a meridian covers about one minute of geographic latitude in an hour.

By definition, one international knot equals one nautical mile per hour, which is exactly 1,852 meters per hour. That works out to approximately 0.51444 m/s, 1.15078 mph, or 1.68781 feet per second.

Definitions

The internationally agreed nautical mile is 1,852 m. The United States adopted this definition in 1954, replacing its earlier US nautical mile of 1,853.248 m. The United Kingdom followed in 1970, switching from the UK Admiralty nautical mile of 6,080 ft (1,853.184 m).

Usage

Speeds of vehicles relative to the fluid they move through—such as boat speeds and airspeeds—are measured in knots. The same unit is used for navigational fluids like ocean currents, tidal streams, river currents, and wind speeds. Consequently, speed over the ground (SOG) and velocity made good (VMG) are also given in knots. Since 1979, the ICAO has listed the knot as permitted for temporary use in aviation, though no end date for that temporary period has been agreed upon as of 2024.

Origin

The knot’s origin lies in the chip log, used at sea until the mid-19th century. A weighted wooden panel was cast over the stern, and a line paid out as the vessel moved.

Knots tied 47 feet 3 inches (14.4018 m) apart passed through a sailor’s fingers while another timed the operation with a 30-second sand-glass (now accepted as 28 seconds). The knot count was used in dead reckoning. This method yields a value of 20.25 inches per second, or 1.85166 km/h—less than 0.02% different from the modern definition.

Modern use

Though the knot is not an SI unit, it remains essential for nautical and aviation use because the nautical mile relates directly to the latitude/longitude coordinate system. On a standard Mercator projection chart, the horizontal scale varies with latitude—for example, the scale from Florida to Greenland changes by a factor of two.

A single graphic scale would be useless. Since a nautical mile is roughly equivalent to a minute of latitude, distances can be measured using dividers and the chart’s latitude scale. Recent British Admiralty charts include a latitude scale down the middle for convenience.

Speed is sometimes incorrectly expressed as “knots per hour,” which would imply acceleration (nautical miles per hour per hour).

In U.S. civil aviation, airworthiness standards originally specified distances in statute miles and speeds in miles per hour. From 1969, these were progressively amended to use nautical miles and knots.

Various abbreviations distinguish airspeed measurements: TAS (true airspeed), KIAS (indicated airspeed), CAS (calibrated airspeed), and EAS (equivalent airspeed). Indicated airspeed is close to true airspeed only at sea level in standard conditions. At 36,000 ft (11,000 m), an indicated 300 kn may correspond to a true airspeed of 500 kn.

Last updated 2026-09-30 from the source article.

Background

Until the mid-19th century, vessel speed at sea was measured using a chip log. This consisted of a wooden panel, attached by line to a reel, and weighted on one edge to float perpendicularly to the water surface and thus present substantial resistance to the water moving around it. The chip log was cast over the stern of the moving vessel and the line allowed to pay out. Knots tied at a distance of 47 feet 3 inches (14.4018 m) from each other, passed through a sailor's fingers, while another sailor used a 30-second sand-glass (28-second sand-glass is the currently accepted timing) to time the operation.

The knot count would be reported and used in the sailing master's dead reckoning and navigation. This method gives a value for the knot of 20+1⁄4 inches per second or 1.85166 kilometres per hour. The difference from the modern definition is less than 0.02%.

Frequently Asked Questions

What symbol do you use for the knot?

The ISO standard symbol, also preferred by the IEEE, is "kn," while the ICAO recommends "kt."

How did the knot get its name?

Sailors originally measured speed by letting a chip-log line, pre-marked with tied knots, drift overboard for a timed interval of 30 or 28 seconds via a sand-glass, then counting how many knots passed. The spacing between those knots was set at 47 feet 3 inches so the count matched nautical miles per hour.

More in Units & Measurement

Sources

Compiled from Wikipedia and the sources listed below. Text from Wikipedia is available under CC BY-SA 4.0; this entry is adapted from it.

Spotted an error? Know more?

Reader corrections go straight into our review queue. Suggest an edit · How this site is sourced

Comments

Loading…
Open in the interactive codex →